Skip to content
Off oil and onto a heat pump (781) 633-7468
HVAC Financing Woburn logo

Rebate conditions, checked

Mass Save Rebate Help in Woburn

Each eligibility condition reviewed before design, so the rebate estimate reflects your actual home.

Brick ranch home with trees and a landscaped yard

Rebates Run on Conditions. We Check Each One.

Up to $8,500. That is the 2026 ceiling for a whole-home air-source system under Mass Save, calculated per ton installed. That figure gets attention. The conditions behind it deserve as much. First, weatherization: the house generally needs to meet the insulation and air sealing level identified by a Home Energy Assessment. Second, equipment: it has to be qualifying cold-climate equipment. Third, occupancy: the home must be lived in full time during the winter. Fourth, the existing system: removal, disconnection or integrated controls, per program rules. Partial-home systems follow a different path and earn smaller rebates. HVAC Financing Woburn reviews each condition against your house before the design is final. If the Home Energy Assessment has not happened, we help arrange the no-cost visit and explain its recommendations, since the insulation and air sealing work it identifies carries large incentives too. Equipment gets selected from the qualifying list during design, not swapped in later. After commissioning, we complete the rebate documents with you and follow them until they are settled. The estimate you receive is labeled as an estimate, with every condition attached.

Rebate Support, Item by Item

Each item below maps to a program requirement.

  • Condition-by-condition review

    Weatherization, equipment, occupancy and old-system rules checked for your home.

  • Assessment coordination

    Help arranging the no-cost Home Energy Assessment and interpreting the report.

  • Weatherization priorities

    Which recommended measures affect whole-home eligibility.

  • Qualifying equipment specified

    Model selection from the qualifying list built into the design.

  • Path clarified

    Whole-home versus partial-home, and what each means for the amount.

  • Old-system compliance

    Removal, disconnection or integrated controls arranged to match the rules.

  • Documents completed

    Rebate paperwork finished after startup and tracked to the end.

  • Status follow-up

    After filing, we watch the rebate and tell you if the program asks for anything more.

Rebate Workflow

  1. Screen

    On the phone, a first pass at the conditions. At the visit, a detailed check against the house itself.

  2. Resolve gaps

    Assessment scheduled, weatherization addressed or design adjusted, whatever the review turned up.

  3. Install, then file

    System commissioned, then the rebate documents prepared with you and followed through.

Owners Delegate the Rebate to Us Because

  • Estimates with conditions attached

    No headline figures without the rules behind them.

  • Designed to qualify

    Program requirements shape the design from the start.

  • Forms off your plate

    We assemble and complete the documents; you sign where required.

  • Conditions reviewed
  • Assessment arranged
  • Qualifying models
  • Paperwork tracked

Want to Know Where Your Home Stands?

Share three facts: heating fuel, year built, and any past energy assessment. We will run through the rebate conditions with you.