Skip to content
Off oil and onto a heat pump (781) 633-7468
HVAC Financing Woburn logo

Off oil, propane and gas

Oil & Gas Heating Replacement in Woburn

Swap an aging boiler or furnace for a heat pump sized to the house, with a clear plan for the old equipment.

Red valve handles on pipes in a mechanical room

Replacing Fossil Heat Is a Design Problem

When an oil boiler or gas furnace reaches the end of its life, the reflex is to buy another one. A heat pump is a different kind of replacement, and it calls for a different kind of planning. First, capacity. The old burner's rating says little about what the house needs today, especially after window or insulation upgrades. We calculate heat loss room by room. Second, distribution. Radiator houses usually suit ductless heads or a mix; houses with ducts can often use them with a new air handler. Third, the old system itself. In each zone the heat pump assumes, the oil, propane or gas equipment comes out or gets disconnected. If you want backup for the deepest cold, integrated controls assign the heat pump nearly all the hours; the old system engages only below a chosen outdoor temperature. Each choice affects which Mass Save rebate path applies, so HVAC Financing Woburn explains the trade-offs before you decide. The result: one system for heating and cooling, no oil deliveries if the tank goes, and a project that can qualify for the rebate and the 0% HEAT Loan.

Replacement Scope

The parts of a changeover we plan and carry out.

  • Load calculation

    Capacity set from measured heat loss, not the old nameplate.

  • Distribution plan

    Ducted, ductless or hybrid, matched to how the house is built.

  • Old equipment removal

    Boiler or furnace removed or disconnected when the heat pump takes over.

  • Backup integration

    Integrated controls that call the old system only in deep cold.

  • Rebate path review

    How removal versus backup changes the rebate, explained up front.

  • Loan documents

    Proposal and authorization form prepared if financing is used.

  • Commissioning

    Heating and cooling tested, then a full controls walkthrough.

Changeover Steps

  1. Evaluate

    Inspect the boiler or furnace, the radiators or ducts and the electrical service. Decide together whether backup heat stays.

  2. Specify

    Design, old-system plan, price, rebate estimate and loan amount delivered in writing.

  3. Execute

    Heat pump installed, old equipment removed, disconnected or integrated, then testing and paperwork.

Why Homeowners Switch With Us

  • Trade-offs explained

    Removal versus backup laid out with the rebate effects of each.

  • Rules respected

    Old equipment handled exactly as the program requires.

  • Cooling included

    The new system air-conditions the house as well.

  • Load calculated
  • Old unit handled
  • Backup controls
  • Heats and cools

Is the Boiler or Furnace Due for Retirement?

Share its age, fuel and recent repair history. We will outline how a heat pump replacement would be designed for your house.